Shop Tools and Hardware Online - Save Money

Tig200 200 Amps Dual Voltage Tig & Stick Welder Square Wave Inverter With Pedal And

Features200a Ac Tig Welder.200a Dc Tig Welder.automatic Dual Voltage (110vac/220vac), Dual Frequency ( 50hz/60hz ).input Voltage: 110 ~ 220 Vac (auto Detected-no Switch Is Necessary).square-wave Inverter For Accurate Aluminum Welding.both Hf Start Hand Torch Control And Precise Foot Pedal Welding Heat Control.housing Protection Grade: Ip21.dimension - 27 X 21 X 11 In.tig / Arc / Stick / Mma Weldingpower Usage: 15 Amps @ 110vac, 30 Amps @ 220 Vac Single Phase.power Supply: 10-200 Amps Ac/dc.welding Bead Quality: Excellent.can Weld Any Kind Of Metal: Aluminum, Mild Steel, Stainless Steel And Other Metals.welding Capability 6 Mm (1/4 Inches).welding Range: 30-200 Amp.duty Cycle: 45% @ 150 Amps.pre Gas Flow: 0.1-1 Seconds.post Gas Flow: 2 - 8 Seconds.cut At 12 Times The Speed Of Soundplasma Cutting Is A Process That Is Used To Cut Steel And Other Metals Using A Plasma Torch. In This Process, An Inert Gas (compressed Air) Is Blown At High Speed Out Of A Nozzle; At The Same Time An Electrical Arc Is Formed Through That Gas From The Nozzle To The Surface That Is Being Cut, Turning Some Of That Gas To Plasma. The Plasma Is Sufficiently Hot To Melt The Metal Being Cut And Moves Sufficiently Fast To Blow Molten Metal Away From The Cut. The Plasma, Which Is Maintained Between The Work-piece And Electrode, Travels At Over 9000 Miles Per Hour (15,000 Km/handle). That’s Over Twelve Times The Speed Of Sound.advantage Of Plasma Vs. Oxy-fuel Torchplasma Does Not Use Expensive, Hazardous Gases, Only Compressed Air. It Imparts Much Less Heat Into The Piece Being Cut, Eliminating Warping. It Does Not Require Ignition. It Leaves Little To No Slag To Clean Up Or Grind Off. The Cost Per Cutting Hour Can Be Less Than Oxy-fuel Since There Is No Gas Cost. It Is Also Much Quicker And Easier. So, You Cut Better, Faster And Inexpensively.

Add to Shopping List